Subject	It appears you are considering valve shrouding to be
Posted by	Jim (Selin Design) on April 15, 2011 at 3:20 PM
	This message has been viewed 152 times.
In Reply To	Why is Valve Shrouding an Issue? posted by S2z on April 15, 2011 at 12:09 PM
Message	a binary condition... meaning that it either is or isn't and the cutoff is 1/8"? I would be cautious about making performance projections that are based on a rule of thumb. www.selindesign.net
Follow Ups	Why is Valve Shrouding an Issue? - S2z 12:09:10 04/15/11 It appears you are considering valve shrouding to be - Jim (Selin Design) 15:20:39 04/15/11 Re: It appears you are considering valve shrouding to be - S2z 17:09:01 04/15/11 Good info. Keep it coming! (n/m) - Zarcasm(Hfd, CT) 19:13:25 04/15/11 To make a long story short :) >>> - ztunerz 09:55:00 04/16/11 btw >> - ztunerz 09:59:37 04/16/11 do you mind sharing your flow numbers? (n/m) - aliaZ 10:22:08 04/16/11 dug it up just for you >>> - ztunerz 10:29:56 04/16/11 this is the exhaust side btw. Intake flows a lot more - ztunerz 10:31:41 04/16/11 thanks (n/m) - aliaZ 15:11:29 04/16/11 Good stuff, guys! (n/m) - Zarcasm(Hfd, CT) 16:36:31 04/16/11 did you simulate the cylinder bore at 88mm - aliaZ 23:22:19 04/18/11 Re: dug it up just for you >>> - S2z 22:29:28 04/20/11 Well its always good to have more experience added - Jim (Selin Design) 15:17:07 04/17/11 AMEN! - S2z 19:08:25 04/18/11 AMEN! - S2z 23:41:29 04/18/11 Thanks, I ordered the book that you referenced (n/m) - aliaZ 17:09:25 04/18/11
Post a Followup	You cannot reply to this message because you are not logged in.