Subject	Re: Re: Test with known good PTU.
Posted by	90GoldZ on April 10, 2011 at 9:10 PM
	This message has been viewed 128 times.
In Reply To	Re: Test with known good PTU. posted by Imissmyz on April 10, 2011 at 09:29 AM
Message	Check the CAS, my Z would only start for a second or two then cutoff. Turns out that the CAS was only sending out signal to the injectors at very low speed, when the motor finally saw ~1k rpm's, the injectors stopped firing, and the engine chut off. No ECU code was thrown. I ended up replacing it and my baby lived again. :)
Follow Ups	Just got a Slicktop Z, can't get it to run - Imissmyz 01:03:06 04/10/11 Test with known good PTU. (n/m) - Draker (Eugene, OR) 04:21:05 04/10/11 Re: Test with known good PTU. - Imissmyz 09:29:27 04/10/11 Re: Re: Test with known good PTU. - 90GoldZ 21:10:31 04/10/11 I read your post and got excited... - Imissmyz 23:15:14 04/10/11 Can you hear the Fuel pump kick on. - Sleeper_TTZ(SeKy) 03:29:36 04/11/11 To check against this problem you can bypass the FPCU - CoHPhasor 21:43:23 04/12/11 Re: To check against this problem you can bypass the FPCU - Imissmyz 14:19:08 04/13/11
Post a Followup	You cannot reply to this message because you are not logged in.