Subject	Yes. My suggestion? Give us more info when asking for help
Posted by	CoHPhasor on April 08, 2011 at 7:46 PM
	This message has been viewed 83 times.
In Reply To	cylinders full of gas and gas in the oil posted by AcesZ on April 08, 2011 at 07:12 PM
Message	I am going to assume that you skipped the part where you installed new injectors and unwittingly bungled the installation, pinching the o-ring. You get to do it all over again, NEW o-rings, incredible amounts of lube. DO NOT try to start it again. REMOVE the gas from the cylinders NOW, get a hose and suck it out, or buy the hand-suction unit from a parts store. The longer the fuel sits in there, the more likely you are to wash out the rings and have to replace them. Go quickly, report back later.
Follow Ups	cylinders full of gas and gas in the oil - AcesZ 19:12:51 04/08/11 Some or all of you injector lower o-rings are pinched - jzack 19:44:53 04/08/11 PS - can run the pressure test by just turning the key -- - jzack 19:49:03 04/08/11 Yes. My suggestion? Give us more info when asking for help - CoHPhasor 19:46:39 04/08/11 Re: Yes. My suggestion? Give us more info when asking for help - AcesZ 21:42:46 04/08/11 Re: cylinders full of gas and gas in the oil - Wisc300Z 21:32:54 04/08/11 I don't recommend pulling a plug and cranking... - CoHPhasor 19:20:06 04/09/11
Post a Followup	You cannot reply to this message because you are not logged in.