Subject	cylinders full of gas and gas in the oil
Posted by	AcesZ on April 08, 2011 at 7:12 PM
	This message has been viewed 112 times.
Message	Hi, I'm new to this site and to getting a z. I have a 90z right now that I'm doing the turbo swap on and I've run into a bit of a problem. I went to start the motor to check and make sure it was gonna run and it cranked over fine but wouldn't fire off, so I checked the plugs and they were shot so I went and got new plugs. I go to crank it over today and the starter just clicks. Well to bypass that I just jumped the 2 posts on the started just to see if I could get it to pop off. Well that's when it quit cranking. So I pulled a plug and sure enough it was full of gas along with gas in the oil. Oh and there was gas pouring out of the exhaust side of the turbo when I was still able to crank it. Anybody out there that can give me some suggestions? Would be much appreciated. Thanks. Nick
Follow Ups	cylinders full of gas and gas in the oil - AcesZ 19:12:51 04/08/11 Some or all of you injector lower o-rings are pinched - jzack 19:44:53 04/08/11 PS - can run the pressure test by just turning the key -- - jzack 19:49:03 04/08/11 Yes. My suggestion? Give us more info when asking for help - CoHPhasor 19:46:39 04/08/11 Re: Yes. My suggestion? Give us more info when asking for help - AcesZ 21:42:46 04/08/11 Re: cylinders full of gas and gas in the oil - Wisc300Z 21:32:54 04/08/11 I don't recommend pulling a plug and cranking... - CoHPhasor 19:20:06 04/09/11
Post a Followup	You cannot reply to this message because you are not logged in.