Subject	Re: Few steps
Posted by	hiser12 on April 03, 2011 at 7:10 PM
	This message has been viewed 132 times.
In Reply To	Few steps posted by Synd (NoVA) on March 31, 2011 at 11:19 PM
Message	well i ran an ecu self diagnostic and it came up code 12, i cleaned out the hks cai today, it breathes a little better. then i performed a MAS test to determine whether its a bad maf or or just a bad connector. i read an article on here about how to test it by putting a volt meter from prong to prong, and the guy listed a spec of what they should ohm out to be and the numbers were wayyyy off. i dont have the numbers on me right now or the url of the original post on how to test it. ill post them up later when i get the home, but basically i need to know how to determine the difference between a bad MAF and a bad connector.
Follow Ups	misfire - hiser12 20:14:57 03/31/11 Limits: NA 142-187psi, TT 128-171psi, Maxdiff 14psi. - Draker (Eugene, OR) 20:22:06 03/31/11 Re: misfire - jaidieray 21:05:37 03/31/11 Re: Re: misfire - hiser12 21:23:05 03/31/11 Few steps - Synd (NoVA) 23:19:56 03/31/11 Re: Few steps - hiser12 19:10:21 04/03/11
Post a Followup	You cannot reply to this message because you are not logged in.