Subject	Plenum pull ehh? cleaned plenum mating surface thoroughly?
Posted by	CoHPhasor on March 31, 2011 at 8:55 PM
	This message has been viewed 284 times.
In Reply To	surging idle posted by ste z on March 28, 2011 at 02:15 PM
Message	New OEM gasket? Made sure all your hose clamps are on? Did your brake/clutch booster vac hoses crack? Made sure you have the routing on your PRVR solenoid are good? Do any deletes while you were in there? Make sure the vac lines in general are routed properly? Basically, the rule of thumb in troubleshooting: If you've worked on something and now something else is broken, it's something you touched. ;-) You need to get real specific about what you did on this pull.
Follow Ups	surging idle - ste z 14:15:12 03/28/11 1) cleaned your TB internals thoroughly? - ZiNnYc 17:21:26 03/28/11 the car ran fine before pleunm pull and its noticeably... - ste z 19:03:44 03/28/11 Nah. - ZiNnYc 20:20:37 03/28/11 FWIW, I don't think it's a TB problem. boost/vacuum leak? (n/m) - Zarcasm(Hfd, CT) 23:21:39 03/28/11 I agree boost/vacuum leak.... - ste z 06:31:48 03/29/11 Plenum pull ehh? cleaned plenum mating surface thoroughly? - CoHPhasor 20:55:18 03/31/11
Post a Followup	You cannot reply to this message because you are not logged in.