Subject	I'd say you've pinched it by over tightening the nut
Posted by	ZILVER-NZ on February 27, 2011 at 6:58 PM
	This message has been viewed 117 times.
In Reply To	Re: Stillen GTZR Fascia installation posted by Fly-Surf on February 27, 2011 at 06:11 PM
Message	Those two nuts in that location are way to tight - try loosen them a little an ease the urethane to become flush. Whatever the case do not paint it with it pinched in like that. The paint will cure with a memory/difficult to rectify.
Follow Ups	Stillen GTZR Fascia installation - Fly-Surf 18:01:30 02/27/11 Re: Stillen GTZR Fascia installation - Fly-Surf 18:11:22 02/27/11 I'd say you've pinched it by over tightening the nut - ZILVER-NZ 18:58:51 02/27/11 Probably true - Fly-Surf 08:37:46 02/28/11 Probably true - Fly-Surf 10:27:20 02/28/11 The divot was there before mounting - Fly-Surf 08:18:54 03/01/11 Interesting choice of word "Divot" - ZILVER-NZ 18:26:04 03/01/11 I appreciate your inputs... - Fly-Surf 06:53:24 03/02/11 Your missing supports (left & Right) - njz 20:30:41 02/27/11 Those supposed "missing" supports only hold the inner liner - ZILVER-NZ 21:26:25 02/27/11 Re: Those supposed "missing" supports only hold the inner liner - njz 07:22:41 02/28/11 Re: Re: Those supposed "missing" supports only hold the inner liner - Fly-Surf 07:39:35 02/28/11 i have this bumper on my car too - youngbloodz 20:00:51 03/03/11 Can you post a picture? - Fly-Surf 07:56:31 03/04/11
Post a Followup	You cannot reply to this message because you are not logged in.