Subject	Stillen GTZR Fascia installation
Posted by	Fly-Surf on February 27, 2011 at 6:01 PM
	This message has been viewed 413 times.
Message	1st hand experience please. I'm installing/test fitting a GTZR Gen 1 on my 90 ZX-TT. I seem to have an "indent" on the passenger side and maybe one (less noticeable) on the driver's side in the same location. Is there some shaving, adjustment, etc... that someone with experience might suggest? Is about 3" in diameter and I guess I could fill with flexible putty before painting BUT I'd prefer to "adjust" it out. Thanks Uploaded with ImageShack.us
Follow Ups	Stillen GTZR Fascia installation - Fly-Surf 18:01:30 02/27/11 Re: Stillen GTZR Fascia installation - Fly-Surf 18:11:22 02/27/11 I'd say you've pinched it by over tightening the nut - ZILVER-NZ 18:58:51 02/27/11 Probably true - Fly-Surf 08:37:46 02/28/11 Probably true - Fly-Surf 10:27:20 02/28/11 The divot was there before mounting - Fly-Surf 08:18:54 03/01/11 Interesting choice of word "Divot" - ZILVER-NZ 18:26:04 03/01/11 I appreciate your inputs... - Fly-Surf 06:53:24 03/02/11 Your missing supports (left & Right) - njz 20:30:41 02/27/11 Those supposed "missing" supports only hold the inner liner - ZILVER-NZ 21:26:25 02/27/11 Re: Those supposed "missing" supports only hold the inner liner - njz 07:22:41 02/28/11 Re: Re: Those supposed "missing" supports only hold the inner liner - Fly-Surf 07:39:35 02/28/11 i have this bumper on my car too - youngbloodz 20:00:51 03/03/11 Can you post a picture? - Fly-Surf 07:56:31 03/04/11
Post a Followup	You cannot reply to this message because you are not logged in.