| The entire system is connected, so one side wouldn't be off-balance. Since it's an entire side you'll need to look at what would affect an entire side. O2 is a good place to start, and no, you shouldn't use carb cleaner on an O2 element. If you don't have a BlaZT cable and software, you should get one, or have a friend come over who has one.
You can look at separate O2, A/F base, and duty cycles for LH and RH sides. Also remember, the opposite side turbo feeds that side's air.
Check the IC and turbo passages for blockages.
There may be a rag stuck in a passage. (You *did* say this motor was just put back together right?) Although the O2 is a strong possibility, so is the stuck rag approach, check for rags first.
|
