Subject	The dual-point sucks.
Posted by	CoHPhasor on February 25, 2011 at 12:27 AM
	This message has been viewed 117 times.
In Reply To	What am I doing wrong? posted by blackomega on February 21, 2011 at 02:07 PM
Message	So here's the main problem with the slave's bleed point: It's not facing up from the highest point on the slave body. You can remove it from the trans (securing the slave's piston) then rotate the body to have the bleeder be the highest point so the bubbles will naturally go there. That should help speed things up.
Follow Ups	What am I doing wrong? - blackomega 14:07:14 02/21/11 Fluid should be fairly clear - maybe there's an issue - jzack 17:04:35 02/21/11 Re: Speed Bleeders - blackomega 18:54:31 02/21/11 In answer to your questions....yes that's how SB's - jzack 22:45:10 02/21/11 re - blackomega 00:07:33 02/22/11 Well the tricks on the Z are letting the slave port - jzack 18:07:41 02/22/11 hours? overnight? - blackomega 21:39:20 02/22/11 Slave has about 2k miles. Master, unknown - blackomega 19:02:23 02/21/11 The dual-point sucks. - CoHPhasor 00:27:07 02/25/11
Post a Followup	You cannot reply to this message because you are not logged in.