Subject	you will need a metal tape measurer or regular ruler
Posted by	blackomega on February 23, 2011 at 12:50 PM
	This message has been viewed 142 times.
In Reply To	Re: yes, check frame posted by MIKEYNISM017 on February 22, 2011 at 05:05 PM
Message	something to measure centimeters or inches and just start measuring point to point on the car's body and suspesion. Make a sketch or table with descriptions of the measurements on the "normal" side and compare to the side you think is uneven. Wheel well, tires, shocks, frame, everything. None of us can figure out what is crooked. Once I posted a similar post and realized it was either up to me or a suspension shop to figure out where it is uneven. Then when you narrow it down you have to figure if it is bent or what to replace. ___________________ "If everybody is thinking alike, somebody isn't thinking." ~~ George S. Patton
Follow Ups	Uneven ride height - MIKEYNISM017 23:29:15 02/20/11 Re: Uneven ride height - njz 13:03:46 02/21/11 Uneven wheel placement - JMartz 13:58:23 02/21/11 yes, check frame - blackomega 15:13:15 02/21/11 Re: yes, check frame - MIKEYNISM017 17:05:33 02/22/11 you will need a metal tape measurer or regular ruler - blackomega 12:50:14 02/23/11
Post a Followup	You cannot reply to this message because you are not logged in.