Subject	CTS is working fine. The problem is my ECU thinks the
Posted by	Worm Boy on February 21, 2011 at 1:38 AM
	This message has been viewed 181 times.
In Reply To	Re: maybe i missed something. why not verify your CTS posted by tognot on February 20, 2011 at 08:31 PM
Message	water temperature is at 203 all the time. The Z hasn't been started in over a week and if I turn the key to the on position, with the car still off, my ECU reads the temp being 203, and my techtom also reads the same. How can this be possible when the engine is cold?
Follow Ups	Why is my ECU reading coolant temperature at 203 degrees? - Worm Boy 01:50:21 02/20/11 Check the thermostat it may not be opening full stroke. - ZUL8TR 07:27:35 02/20/11 Thermostat is good. I had bought one from AutoZone - Worm Boy 19:39:41 02/20/11 Do the following - njz 11:54:11 02/20/11 Re: maybe i missed something. why not verify your CTS - tognot 20:31:11 02/20/11 CTS is working fine. The problem is my ECU thinks the - Worm Boy 01:38:52 02/21/11 Ohm out the harness from temp sensor connector to the ecu - Wright (Ca) 09:59:35 02/21/11 2nd - njz 11:09:14 02/21/11 how would i do that? - Worm Boy 01:25:40 02/22/11
Post a Followup	You cannot reply to this message because you are not logged in.