Subject	Re: I'm going to bleed it like this
Posted by	Obeeone on February 10, 2011 at 6:14 PM
	This message has been viewed 122 times.
In Reply To	I'm going to bleed it like this posted by Cd_ny on February 09, 2011 at 07:00 PM
Message	If you can somehow work the slave down to the transmission while everything is still connected that might work, but if you have to disconnect the slave to re-run the line then you will just have to bleed the system again. One thing that will do for you is similar to a bench bleed for the master cylinder though. I would just install everything as it would be then bleed the system then.
Follow Ups	New slave cylinder question - Cd_ny 16:22:16 02/09/11 can you post a pic? (n/m) - Shiers69 16:47:01 02/09/11 Make sure the bleeder valve on the slave cylinder is open... (n/m) - HK'S Z 17:07:04 02/09/11 Did you bleed the system before mounting the slave cylinder? (n/m) - ZX-infinity (Dallas) 17:32:02 02/09/11 No, the slave is still in the box - Cd_ny 18:33:44 02/09/11 I'm going to bleed it like this - Cd_ny 19:00:40 02/09/11 Re: I'm going to bleed it like this - Obeeone 18:14:25 02/10/11 push it in? (n/m) - aliaZ 05:57:14 02/10/11 2nd, the piston pushes the lever on the tranny - blackomega 11:55:41 02/10/11 Re: "push the lever on the tranny out of the way..." - Black95 12:38:19 02/10/11 yep (n/m) - aliaZ 15:41:27 02/10/11 2nd. (n/m) - Stadsport (PHX) 16:20:11 02/10/11
Post a Followup	You cannot reply to this message because you are not logged in.