Subject	it probably would
Posted by	Khronik on February 08, 2011 at 1:30 PM
	This message has been viewed 123 times.
In Reply To	You didnt try hard enough. posted by ZiNnYc on February 08, 2011 at 12:26 PM
Message	I got a cheater bar and was more worried about breaking the link assembly or sumthing else anytime i put a decent amount of pressure on the breaker bar the entire assembly holding the rotor would move probably wont break anything but the impact gun causes no stress on other parts, felt safer
Follow Ups	Tension Rod Removal - Khronik 11:22:33 02/07/11 Soak well with PB Blaster or other penetrant first.. - ttz'in (NorCal) 11:29:31 02/07/11 Have you tried heat? (n/m) - KongZTT GT28RS MD 11:57:51 02/07/11 no i havent - Khronik 12:11:08 02/07/11 Also,try to give nut some motion in the tight direction - ttz'in (NorCal) 12:23:12 02/07/11 I've had good luck with Kroil - ae300z 19:18:43 02/07/11 Just use your impact gun... This is what it is for. (n/m) - flashstar 09:43:12 02/08/11 impact only - Khronik 11:44:32 02/08/11 You didnt try hard enough. - ZiNnYc 12:26:59 02/08/11 it probably would - Khronik 13:30:40 02/08/11 Impact (n/m) - John (MD) 14:04:48 02/08/11
Post a Followup	You cannot reply to this message because you are not logged in.