Subject	You didnt try hard enough.
Posted by	ZiNnYc on February 08, 2011 at 12:26 PM
	This message has been viewed 100 times.
In Reply To	Tension Rod Removal posted by Khronik on February 07, 2011 at 11:22 AM
Message	Ive never used an impact gun on any of the many tension rods Ive taken off. of course since you have the impact, use it, but just saying that it definitely isnt required. A long breaker bar/pipe-over-the-ratchet works everytime.
Follow Ups	Tension Rod Removal - Khronik 11:22:33 02/07/11 Soak well with PB Blaster or other penetrant first.. - ttz'in (NorCal) 11:29:31 02/07/11 Have you tried heat? (n/m) - KongZTT GT28RS MD 11:57:51 02/07/11 no i havent - Khronik 12:11:08 02/07/11 Also,try to give nut some motion in the tight direction - ttz'in (NorCal) 12:23:12 02/07/11 I've had good luck with Kroil - ae300z 19:18:43 02/07/11 Just use your impact gun... This is what it is for. (n/m) - flashstar 09:43:12 02/08/11 impact only - Khronik 11:44:32 02/08/11 You didnt try hard enough. - ZiNnYc 12:26:59 02/08/11 it probably would - Khronik 13:30:40 02/08/11 Impact (n/m) - John (MD) 14:04:48 02/08/11
Post a Followup	You cannot reply to this message because you are not logged in.