Subject	Re: replacing rack & pinion boot
Posted by	jameyguy on February 06, 2011 at 4:00 AM
	This message has been viewed 152 times.
In Reply To	replacing rack & pinion boot posted by jameyguy on February 05, 2011 at 01:40 AM
Message	Does anyone know where I can buy replacement rubber for the tie rod end? If it doesn't come out with the puller I have, I'll have to use a pickle fork which will ruin the rubber. Thanks!
Follow Ups	replacing rack & pinion boot - jameyguy 01:40:37 02/05/11 you got mail - njz 01:55:19 02/05/11 I would remove outer tie rod (mark it before) - KongZTT GT28RS MD 01:59:08 02/05/11 Watching late night TV? (n/m) - njz 02:13:22 02/05/11 always up late :) (n/m) - KongZTT GT28RS MD 09:57:56 02/05/11 Yup, too much stress..too much going on, getting old (n/m) - jameyguy 03:26:55 02/06/11 Re: replacing rack & pinion boot - njz 02:11:52 02/05/11 Silver/duct tape the outer tie-rod thread up to nut - ttz'in (NorCal) 02:17:40 02/05/11 Re: replacing rack & pinion boot - jameyguy 04:00:58 02/06/11 You can probably get it off by threading a nut on half way. - KongZTT GT28RS MD 10:43:09 02/06/11
Post a Followup	You cannot reply to this message because you are not logged in.