Subject	Why? Y is crooked letter my friend. Who knows....
Posted by	ttz'in (NorCal) on February 05, 2011 at 11:26 AM
	This message has been viewed 165 times.
In Reply To	Re: Dremel method isn't a bad idea. You just over did it. posted by joe645733 on February 05, 2011 at 12:37 AM
Message	Maybe it took the ecu some time to see something wasn't right. The O2 sensor connectors are the same as the VTC connector (I think) and often get mixed up. A connector could have come off, or have corrision.( green color) You have the IACV on rear driver side of engine and it has 3 connectors. So start with connectors and you'll probably find out "Y".
Follow Ups	Z running bad/dying after plenum pull. - joe645733 23:18:26 02/04/11 Dremel method isn't a bad idea. You just over did it. - ttz'in (NorCal) 00:02:17 02/05/11 Re: Dremel method isn't a bad idea. You just over did it. - joe645733 00:37:40 02/05/11 Why? Y is crooked letter my friend. Who knows.... - ttz'in (NorCal) 11:26:28 02/05/11 Re: Why? Y is crooked letter my friend. Who knows.... - joe645733 13:21:31 02/05/11 Re: Why? Y is crooked letter my friend. Who knows.... - joe645733 16:46:52 02/05/11 Connections in the back - CoHPhasor 20:50:43 02/05/11 anyone else have any other suggestions? - joe645733 12:42:43 02/09/11 anyone else have any other suggestions? - joe645733 13:05:57 02/09/11 I would say connector issue too (n/m) - KongZTT GT28RS MD 02:00:48 02/05/11
Post a Followup	You cannot reply to this message because you are not logged in.