Subject	Re: replacing rack & pinion boot
Posted by	njz on February 05, 2011 at 2:11 AM
	This message has been viewed 191 times.
In Reply To	replacing rack & pinion boot posted by jameyguy on February 05, 2011 at 01:40 AM
Message	Lift the wheels of the ground Mark the nut poison by the outer tie rod and turn the inner tie rod until it separates, slide the boot off then reinstall
Follow Ups	replacing rack & pinion boot - jameyguy 01:40:37 02/05/11 you got mail - njz 01:55:19 02/05/11 I would remove outer tie rod (mark it before) - KongZTT GT28RS MD 01:59:08 02/05/11 Watching late night TV? (n/m) - njz 02:13:22 02/05/11 always up late :) (n/m) - KongZTT GT28RS MD 09:57:56 02/05/11 Yup, too much stress..too much going on, getting old (n/m) - jameyguy 03:26:55 02/06/11 Re: replacing rack & pinion boot - njz 02:11:52 02/05/11 Silver/duct tape the outer tie-rod thread up to nut - ttz'in (NorCal) 02:17:40 02/05/11 Re: replacing rack & pinion boot - jameyguy 04:00:58 02/06/11 You can probably get it off by threading a nut on half way. - KongZTT GT28RS MD 10:43:09 02/06/11
Post a Followup	You cannot reply to this message because you are not logged in.