Subject	I would say connector issue too (n/m)
Posted by	KongZTT GT28RS MD on February 05, 2011 at 2:00 AM
	This message has been viewed 171 times.
In Reply To	Z running bad/dying after plenum pull. posted by joe645733 on February 04, 2011 at 11:18 PM
Message
Follow Ups	Z running bad/dying after plenum pull. - joe645733 23:18:26 02/04/11 Dremel method isn't a bad idea. You just over did it. - ttz'in (NorCal) 00:02:17 02/05/11 Re: Dremel method isn't a bad idea. You just over did it. - joe645733 00:37:40 02/05/11 Why? Y is crooked letter my friend. Who knows.... - ttz'in (NorCal) 11:26:28 02/05/11 Re: Why? Y is crooked letter my friend. Who knows.... - joe645733 13:21:31 02/05/11 Re: Why? Y is crooked letter my friend. Who knows.... - joe645733 16:46:52 02/05/11 Connections in the back - CoHPhasor 20:50:43 02/05/11 anyone else have any other suggestions? - joe645733 12:42:43 02/09/11 anyone else have any other suggestions? - joe645733 13:05:57 02/09/11 I would say connector issue too (n/m) - KongZTT GT28RS MD 02:00:48 02/05/11
Post a Followup	You cannot reply to this message because you are not logged in.