Subject	Re: Re: Reply to aliaZ
Posted by	Snowmansdsm09 on February 03, 2011 at 12:13 AM
	This message has been viewed 89 times.
In Reply To	Re: Reply to aliaZ posted by aliaZ on February 02, 2011 at 05:02 PM
Message	:No worries. What I did was make a metal collar as a spacer, and used the banjo bolt and 2 copper washers to seal it up. You could do the same with a bolt and 1 washer. It is not under pressure, so just find a way to plug it. : I used the original banjo bolt as well plus copper spacer & crush washers. I also plugged the oriface on that banjo bolt with a metal dowel pin just to make sure no leaks, overkill yes. All is good. Now if I can just figure out how these brackets go back together haha.
Follow Ups	TT Power Steering HICAS 'de-vane' question. - Snowmansdsm09 22:19:59 02/01/11 Re: TT Power Steering HICAS 'de-vane' question. - aliaZ 09:11:36 02/02/11 Reply to aliaZ - Snowmansdsm09 14:36:35 02/02/11 Re: Reply to aliaZ - aliaZ 17:02:06 02/02/11 Re: Re: Reply to aliaZ - Snowmansdsm09 00:13:40 02/03/11 If the vanes are for the HICAS - ZXRider 15:49:04 02/02/11 all PS pumps have vanes - aliaZ 16:55:23 02/02/11
Post a Followup	You cannot reply to this message because you are not logged in.