Subject	yeah that's the most direct approach
Posted by	KasbeKZ(VA) on February 02, 2011 at 2:33 AM
	This message has been viewed 141 times.
In Reply To	Can you get the channel locks on the bolts and bend posted by ttz'in (NorCal) on February 01, 2011 at 11:43 PM
Message	this with a little finesse would probably get the job done. the issue is that the whole area is just so flattened that it's hard to get a tool on any of it! i took a few pictures but it was way too dark under there. i'll give it another try.
Follow Ups	rocker panel damage from jacks? - KasbeKZ(VA) 22:42:34 02/01/11 Can you get the channel locks on the bolts and bend - ttz'in (NorCal) 23:43:59 02/01/11 yeah that's the most direct approach - KasbeKZ(VA) 02:33:29 02/02/11 Know what you mean, can get pretty bent up. (n/m) - ttz'in (NorCal) 02:57:30 02/02/11 Use a flathead or a chisel to pry it up a bit - -Grimm- 22:05:00 02/02/11 that's a good idea. (n/m) - KasbeKZ(VA) 08:09:54 02/03/11
Post a Followup	You cannot reply to this message because you are not logged in.