Subject	Ok I think I figured it out
Posted by	Rob'Z on February 01, 2011 at 8:20 PM
	This message has been viewed 107 times.
In Reply To	Here's a diagram that may help but I still have questions posted by Rob'Z on February 01, 2011 at 05:50 PM
Message	Bench testing with a Ohm meter I got the following results..... I used the 200k setting on my meter. Black and white wires on the external plug in the closed position is .4 and fully open (a tad past 90*) it reads 7.7 Black and red wire reading 7.6 at all times.   The swapped engine sensor reads .9 closed and 4.5 open with a reading of 3.6 at all times on the supply wire. I'm going to splice in the Z TPS to the swapped engine harness and see how it runs. Rob
Follow Ups	TPS plug(s)?? Please help me identify the wires - Rob'Z 22:40:34 01/31/11 Think you are correct on the voltage Rob and the... - ttz'in (NorCal) 00:58:13 02/01/11 Do you know where I can find a wiring diagram? - Rob'Z 08:51:54 02/01/11 Re: TPS plug(s)?? Please help me identify the wires - -Grimm- 09:08:08 02/01/11 Here's a diagram that may help but I still have questions - Rob'Z 17:50:53 02/01/11 Ok I think I figured it out - Rob'Z 20:20:27 02/01/11
Post a Followup	You cannot reply to this message because you are not logged in.