Subject	I am pretty sure the 2.5" will clamp down to a smaller size
Posted by	KongZTT GT28RS MD on February 01, 2011 at 10:12 AM
	This message has been viewed 81 times.
In Reply To	Oh right. Well, anyway, it was just a thought. You are posted by evan_aggie on February 01, 2011 at 09:47 AM
Message	I can't remember the inlet size (exactly of the gt28r) Since it had a flange. The inside of the flange did have a "step" to match the size of the compressor wheel. You will most likely have to remove the turbo again anyways to get this all done.. or atleast remove the compressor housing from the turbo. _________________________________________________________________________ ~~~ Sig starts below ~~~ ================================================================= NO, This picture is not photoshopped. MySpace for those who have em' AIM:Shawn300zxTT "-Any closeups on the nuts? - zboost(tx) 19:17:53 08/08/05 -Not really something you want to ask another man about... (n/m) - LordZ 19:24:00 08/08/05" "I just took 45 min and scrubbed the heck out of my rear" teambushido(San Diego, CA) 19:24:51 12/11/04 -1991 Stage _ TT 5spd (Upgraded to hell and back) -1990 Super White 2+2 Na Stage 3 Auto (Deceased :( ) -1990 Cherry Red Pearl ,Auto Coupe (Parts car) -1990 11 Sec Eagle Talon Tsi AWD, (SOLD!) -2001 Ford F-150 Crew cab, 5.4 Triton v8.. Tow bitch -1997 Acura 2.2 CL, 5spd. Daily Driver.. great little car! -2004 Honda CBR 600RR (Candy blue, FOR SALE)
Follow Ups	custom compressor inlet hose - evan_aggie 21:55:45 01/31/11 It would have been easier if you got GT2560R (aka gt28R) - KongZTT GT28RS MD 00:35:57 02/01/11 Yeah, I saw those on atpturbo. The only problem is that - evan_aggie 07:52:58 02/01/11 The flange they use has a taper in the center. (n/m) - KongZTT GT28RS MD 09:27:14 02/01/11 You also could cut the flanges off the stock inlet piping - KongZTT GT28RS MD 09:35:20 02/01/11 How about a muffler shop? I don't anyone in particular. (n/m) - evan_aggie 09:43:15 02/01/11 They may be able to.. but look into the phone book for - KongZTT GT28RS MD 10:13:32 02/01/11 Anyone ever used exhaust hose as inlet piping? - evan_aggie 08:03:43 02/01/11 You dont have to worry about using somthing that handles PSI - KongZTT GT28RS MD 09:25:21 02/01/11 Oh right. Well, anyway, it was just a thought. You are - evan_aggie 09:47:47 02/01/11 I am pretty sure the 2.5" will clamp down to a smaller size - KongZTT GT28RS MD 10:12:30 02/01/11 53mm inner diameter is identical for 2560 and 2554. - evan_aggie 11:30:19 02/01/11 I did like Kong suggested. Use the ATP flanges! - greyzx (now blue) 17:02:57 02/03/11
Post a Followup	You cannot reply to this message because you are not logged in.