Subject	The flange they use has a taper in the center. (n/m)
Posted by	KongZTT GT28RS MD on February 01, 2011 at 9:27 AM
	This message has been viewed 90 times.
In Reply To	Yeah, I saw those on atpturbo. The only problem is that posted by evan_aggie on February 01, 2011 at 07:52 AM
Message
Follow Ups	custom compressor inlet hose - evan_aggie 21:55:45 01/31/11 It would have been easier if you got GT2560R (aka gt28R) - KongZTT GT28RS MD 00:35:57 02/01/11 Yeah, I saw those on atpturbo. The only problem is that - evan_aggie 07:52:58 02/01/11 The flange they use has a taper in the center. (n/m) - KongZTT GT28RS MD 09:27:14 02/01/11 You also could cut the flanges off the stock inlet piping - KongZTT GT28RS MD 09:35:20 02/01/11 How about a muffler shop? I don't anyone in particular. (n/m) - evan_aggie 09:43:15 02/01/11 They may be able to.. but look into the phone book for - KongZTT GT28RS MD 10:13:32 02/01/11 Anyone ever used exhaust hose as inlet piping? - evan_aggie 08:03:43 02/01/11 You dont have to worry about using somthing that handles PSI - KongZTT GT28RS MD 09:25:21 02/01/11 Oh right. Well, anyway, it was just a thought. You are - evan_aggie 09:47:47 02/01/11 I am pretty sure the 2.5" will clamp down to a smaller size - KongZTT GT28RS MD 10:12:30 02/01/11 53mm inner diameter is identical for 2560 and 2554. - evan_aggie 11:30:19 02/01/11 I did like Kong suggested. Use the ATP flanges! - greyzx (now blue) 17:02:57 02/03/11
Post a Followup	You cannot reply to this message because you are not logged in.