Subject	Anyone ever used exhaust hose as inlet piping?
Posted by	evan_aggie on February 01, 2011 at 8:03 AM
	This message has been viewed 97 times.
In Reply To	It would have been easier if you got GT2560R (aka gt28R) posted by KongZTT GT28RS MD on February 01, 2011 at 12:35 AM
Message	I just started wondering since the marine exhaust hose handles high PSI and is bendable as well. A 2.5" 6 ft length is ~$100 and has a bending radius of 5".
Follow Ups	custom compressor inlet hose - evan_aggie 21:55:45 01/31/11 It would have been easier if you got GT2560R (aka gt28R) - KongZTT GT28RS MD 00:35:57 02/01/11 Yeah, I saw those on atpturbo. The only problem is that - evan_aggie 07:52:58 02/01/11 The flange they use has a taper in the center. (n/m) - KongZTT GT28RS MD 09:27:14 02/01/11 You also could cut the flanges off the stock inlet piping - KongZTT GT28RS MD 09:35:20 02/01/11 How about a muffler shop? I don't anyone in particular. (n/m) - evan_aggie 09:43:15 02/01/11 They may be able to.. but look into the phone book for - KongZTT GT28RS MD 10:13:32 02/01/11 Anyone ever used exhaust hose as inlet piping? - evan_aggie 08:03:43 02/01/11 You dont have to worry about using somthing that handles PSI - KongZTT GT28RS MD 09:25:21 02/01/11 Oh right. Well, anyway, it was just a thought. You are - evan_aggie 09:47:47 02/01/11 I am pretty sure the 2.5" will clamp down to a smaller size - KongZTT GT28RS MD 10:12:30 02/01/11 53mm inner diameter is identical for 2560 and 2554. - evan_aggie 11:30:19 02/01/11 I did like Kong suggested. Use the ATP flanges! - greyzx (now blue) 17:02:57 02/03/11
Post a Followup	You cannot reply to this message because you are not logged in.