Subject	consider this...
Posted by	icsamerica on January 27, 2011 at 12:45 PM
	This message has been viewed 129 times.
In Reply To	What now? posted by RevHard on January 27, 2011 at 12:14 PM
Message	drill a proper hole for an easy out, then before you attempt to twist it out with the extractor heat up the plug and surrounding area with a torch. Propane or map gas will suffice. Once hot it should come out easy. If not then shock cool it with a spray of water and try heating it up again. The hot cold cycle may break it loose enough to remove. If it wont come out at all drill and retap 1/2 npt. You may need to make a guide out of 1/4 steel as a guide to keep the drill bit centered. . http://www.icsamerica.com/zstory
Follow Ups	What now? - RevHard 12:14:27 01/27/11 Easy-outs. - TeddyZ(SFC) 12:22:51 01/27/11 Easy-outs aren't always that easy. - Shiers69 12:25:18 01/27/11 true... the name is misleading... - TeddyZ(SFC) 12:54:28 01/27/11 PB blaster (n/m) - Shiers69 16:46:01 01/27/11 consider this... - icsamerica 12:45:48 01/27/11 I wouldn't shock the block. Heat it up, PB blast it sure - BigTDogg (MA) 12:55:43 01/27/11 2nd - aliaZ 15:21:14 01/27/11 You going to make another comeback? (n/m) - BoneZ 14:18:57 01/27/11 what about sticking a nut over the broken part and filling - KongZTT GT28RS MD 13:07:56 01/27/11 huh? what?? - TeddyZ(SFC) 13:13:01 01/27/11 He meant if there was still some threads sticking out - whip 13:23:04 01/27/11 actually.. you dont really need any threads sticking out - KongZTT GT28RS MD 13:31:32 01/27/11 I have played this game! I tried an easy out. That broke - Hoppy2 13:23:20 01/27/11
Post a Followup	You cannot reply to this message because you are not logged in.