 |
   |
|
| |
|
|
| Subject |
Manual transmission flush |
|
| |
|
|
| Posted by |
BlackholeZ on January 24, 2011 at 4:25 PM |
|
| |
This message has been viewed 195 times. |
|
| |
|
|
| |
|
|
| Message |
It's time to install my extra tranny, unfortunately it sat at my parent's house for the last few years, bell housing down, and somehow the rubber glove covering the output came off. It was pretty undisturbed, but undoubtedly got some dust and stuff in it. I am thinking of filling it with standard oil to flush it before I put in the MT90. Maybe flush with a bit of Marvel oil too? This is a ~60k Trans that I got with a replacement engine years ago. I just want to be cautious and make sure it will last.
![]() src="http://img70.imageshack.us/img70/939/newsigwk6.jpg"
alt="I love my baby"/>"Capitalization is the difference between helping your Uncle
Jack off a horse, and helping your uncle jack off a horse."
"Ahhh, VTEC. All of the lag, none of the turbo. It's like waiting
for bad sex."
"'she' also likes to swap since I think I am going to need to
give her to woody again." - Dvlhntr
"full alphabetic boost mode"
- ChristopherTheOne
"Roses are red, violets are blue, stages are gay, and so are
you." - ZEngineer
"Hoses as hard as Zengineer at a Hot Imports Night event" -
Gizmo
"Two oil eating, angry, spinning triangles of death." - turtleboy
on rotary engines |
|
| |
|
|
| Follow Ups |
- Manual transmission flush - BlackholeZ
16:25:32 01/24/11
|
|
| |
|
|
Post a
Followup |
You cannot reply to this message because you are not logged in.
|
|
| |
|
|
| |
|
|
|
