Subject	If you are working on the R230 diff you really need a
Posted by	Barry(TN) on January 20, 2011 at 7:28 PM
	This message has been viewed 385 times.
In Reply To	How do you find bolt sizes from FSM? (Changing Diff seal) posted by Adamo on January 20, 2011 at 07:19 PM
Message	service manual for guidance. The pinion bearing pre-load will be affected when you remove and replace the nut that holds the companion flange. A new crush sleeve inside the differential will be required to establish the correct pre-load on the pinion bearings. This is not a quick remove & replace job on the R230 diff.
Follow Ups	How do you find bolt sizes from FSM? (Changing Diff seal) - Adamo 19:19:29 01/20/11 If you are working on the R230 diff you really need a - Barry(TN) 19:28:49 01/20/11 Ya i was reading through the FSM and was a bit confused... - Adamo 19:50:42 01/20/11 You'll need one hell of a press the crush sleeve. (n/m) - ShakaShaun(Denver) 19:55:02 01/20/11 Hmm, maybe ill bring it to a shop, shouldn't cost too much? (n/m) - Adamo 19:58:32 01/20/11 Look at this video, What joe wrote - njz 21:18:45 01/20/11 Hmm video makes it looks not so bad, so i dont need a new - Adamo 21:28:06 01/20/11 It's really not all as bad as it seems. - Spddracer 20:54:42 01/20/11 I think ill bring it to a mechanic tomorrow to be safe. - Adamo 21:19:20 01/20/11 You don't. (n/m) - Bernie (NoVA) 20:53:26 01/20/11
Post a Followup	You cannot reply to this message because you are not logged in.