Subject	Just changed both 02 sensors to narrow things down and no
Posted by	scooter4zx on January 20, 2011 at 4:30 PM
	This message has been viewed 95 times.
In Reply To	Re: I tried 3 seperate resistors (2 1mega ohm resistors 1/2 posted by DoomDay300 on January 18, 2011 at 11:47 PM
Message	change.
Follow Ups	code 34 det. sensor problem - scooter4zx 18:03:50 01/15/11 Re: code 34 det. sensor problem (n/m) - njz 19:54:08 01/15/11 Recheck your work, (n/m) - njz 19:57:32 01/15/11 Check for swapped connectors - DE944 00:12:32 01/16/11 The connectors are connected correctly - scooter4zx 09:39:06 01/16/11 Just in case you need a new one. - jschrauwen 09:56:41 01/16/11 thanks (n/m) - scooter4zx 10:38:18 01/16/11 now i'm completly confused. - scooter4zx 12:19:27 01/16/11 Could something else throw a 34 code? (n/m) - scooter4zx 13:04:55 01/16/11 I know you said it already, but you're SURE of the connector - CoHPhasor 14:07:24 01/16/11 the vtc connector has a white sheath on it with black and - scooter4zx 14:56:51 01/16/11 I just cleared the ecu again and reversed the vtc and - scooter4zx 15:27:19 01/16/11 allittle change here - scooter4zx 18:34:16 01/16/11 Are your stock boost solenoids discod since you have a BC? (n/m) - Woody75 (Denver) 09:33:36 01/17/11 disconnected and removed. (n/m) - scooter4zx 17:24:02 01/17/11 Then safety boost is no longer an option. (n/m) - Woody75 (Denver) 19:43:53 01/17/11 woody how is it possible i'm throwing 34 with the resistor - scooter4zx 23:07:40 01/17/11 Re: woody how is it possible i'm throwing 34 with the resistor - DoomDay300 23:58:36 01/17/11 thanks for the input doomday but thats where i had it wired - scooter4zx 16:33:52 01/18/11 Re: thanks for the input doomday but thats where i had it wired - DoomDay300 17:19:39 01/18/11 I tried 3 seperate resistors (2 1mega ohm resistors 1/2 - scooter4zx 18:41:46 01/18/11 Re: I tried 3 seperate resistors (2 1mega ohm resistors 1/2 - DoomDay300 23:47:51 01/18/11 Just changed both 02 sensors to narrow things down and no - scooter4zx 16:30:10 01/20/11 Re - DoomDay300 01:19:24 01/21/11
Post a Followup	You cannot reply to this message because you are not logged in.