Subject	You may have to put a bit of a load on it to get the nut
Posted by	Brett@AwesomeZ on January 17, 2011 at 10:51 AM
	This message has been viewed 69 times.
In Reply To	Front lower control arm help please... posted by Shutoburner on January 16, 2011 at 05:37 PM
Message	off without spinning the ball joint. See if you can get a pry bar in there while you are turning the nut. 281-219-0015 www.awesomez.org Email= bretthobbs13b@hotmail.com
Follow Ups	Front lower control arm help please... - Shutoburner 17:37:17 01/16/11 I think the ball joints are press fit - Shiers69 18:16:03 01/16/11 Re: I think the ball joints are press fit - Shutoburner 18:22:47 01/16/11 Re: Re: I think the ball joints are press fit - brian913 06:43:11 01/17/11 You may have to put a bit of a load on it to get the nut - Brett@AwesomeZ 10:51:43 01/17/11 Put a jack underneath the ball joint.. put load on it. - KongZTT GT28RS MD 11:56:22 01/17/11 Re: Put a jack underneath the ball joint.. put load on it. - Shutoburner 15:24:00 01/17/11 Re: Re: Put a jack underneath the ball joint.. put load on it. - Shutoburner 18:53:53 01/17/11 glad it worked out.. (n/m) - KongZTT GT28RS MD 19:04:01 01/17/11
Post a Followup	You cannot reply to this message because you are not logged in.