Subject	Front lower control arm help please...
Posted by	Shutoburner on January 16, 2011 at 5:37 PM
	This message has been viewed 158 times.
Message	Hi,Lost control of my car in rain and hit the curb pretty hard...lower front arm is bent pretty bad. Got the pin off above the nut and the nut is moving, but so is the ball joint below under the rubber cone. Thought this might be a vice grip, but it's just free spinning, and I can't think of a way to get it out other than to cut the nut off. Any hints? or ways to get the nut off? Thanks guys!
Follow Ups	Front lower control arm help please... - Shutoburner 17:37:17 01/16/11 I think the ball joints are press fit - Shiers69 18:16:03 01/16/11 Re: I think the ball joints are press fit - Shutoburner 18:22:47 01/16/11 Re: Re: I think the ball joints are press fit - brian913 06:43:11 01/17/11 You may have to put a bit of a load on it to get the nut - Brett@AwesomeZ 10:51:43 01/17/11 Put a jack underneath the ball joint.. put load on it. - KongZTT GT28RS MD 11:56:22 01/17/11 Re: Put a jack underneath the ball joint.. put load on it. - Shutoburner 15:24:00 01/17/11 Re: Re: Put a jack underneath the ball joint.. put load on it. - Shutoburner 18:53:53 01/17/11 glad it worked out.. (n/m) - KongZTT GT28RS MD 19:04:01 01/17/11
Post a Followup	You cannot reply to this message because you are not logged in.