Subject	Re: Rack and pinion question
Posted by	gbhrps on January 13, 2011 at 9:34 PM
	This message has been viewed 78 times.
In Reply To	Rack and pinion question posted by sunroof446 on January 13, 2011 at 07:14 AM
Message	Take photos of the tie rods at each end at the lock nuts for reference. As well, count the number of visible threads on each tie rod up until the lock nut. Remove the old rack, install the new one, and set each tie rod up to the appropriate thread counts you recorded by count and by photo. Everything will have to be dead nuts on as it was before. Good Luck!
Follow Ups	Rack and pinion question - sunroof446 07:14:41 01/13/11 Re: Rack and pinion question - gbhrps 21:34:52 01/13/11 Re: Re: Rack and pinion question - gbhrps 21:42:51 01/13/11
Post a Followup	You cannot reply to this message because you are not logged in.