Subject	I am already running an 8bit Z1 ecu I just cannot pull
Posted by	robzone0911 on January 12, 2011 at 2:55 PM
	This message has been viewed 136 times.
In Reply To	Well you have a few options... posted by Zinn2win on January 12, 2011 at 02:44 PM
Message	diagnostics from it or plug a Blatz into it... I would have to change out the interior harness to put the OBD I port in... I'm not sure which would be cheaper or easier... I would like to keep it OBD I if I could observe my engine performance on my computer... Before Swap After Swap
Follow Ups	91 JDM Engine on a 96 TT ECU Question... - robzone0911 13:57:06 01/12/11 Well you have a few options... - Zinn2win 14:44:07 01/12/11 I am already running an 8bit Z1 ecu I just cannot pull - robzone0911 14:55:05 01/12/11 Just add an OBD1 connector to your ECU harness. (n/m) - DVDBURN (MD) 15:41:16 01/12/11 Re: Just add an OBD1 connector to your ECU harness. - robzone0911 17:02:59 01/12/11 Re: I am already running an 8bit Z1 ecu I just cannot pull - njz 20:03:48 01/12/11 my ecu isn't hooked up to my OBD II connector. The - robzone0911 20:34:46 01/12/11
Post a Followup	You cannot reply to this message because you are not logged in.