Subject	Nothing special
Posted by	Stadsport (PHX) on January 11, 2011 at 3:27 PM
	This message has been viewed 85 times.
In Reply To	what hardware did you use? posted by blackomega on January 11, 2011 at 02:46 PM
Message	I was at Home Depot for something else and thought "Oh, I should try this!" and picked up some nuts + bolts and washers. Picking out the washers was the hardest part since I wanted them to be big enough to be effective, but not so huge they wouldn't fit in the little lip. You'd have better luck at Ace. Part of the reason I actually pulled everything off was to see if there was any evidence of a front-end collision. Everything looked perfectly straight and original, so I'm just going to blame years of flexing and pulling on the front bumper...
Follow Ups	another late night tripping out on the Z (front bumper fit) - blackomega 02:26:43 01/11/11 There isn't really a trick.. - Draker (Eugene, OR) 10:08:39 01/11/11 that would have been too easy (n/m) - blackomega 11:09:00 01/11/11 2ed. Take it off and start again. Something must be - not4resaleZ 15:47:37 01/11/11 It sometimes hangs up on a fog light housing. (n/m) - Wright (Ca) 13:37:54 01/11/11 I've never been able to get it to fit just right. - Stadsport (PHX) 13:49:50 01/11/11 wow. - blackomega 14:14:26 01/11/11 The only obstruction I've ever noticed - Stadsport (PHX) 14:31:08 01/11/11 what hardware did you use? - blackomega 14:46:17 01/11/11 Nothing special - Stadsport (PHX) 15:27:07 01/11/11 nice - blackomega 15:45:27 01/11/11 well your method is what I ended up doing - blackomega 13:57:05 01/12/11
Post a Followup	You cannot reply to this message because you are not logged in.