Subject	Boost cuts off at 7-10psi, not getting detonation code. What
Posted by	blkrocket on January 10, 2011 at 12:20 AM
	This message has been viewed 121 times.
Message	I recently had a JDM engine installed. I do not have a history on the car running prior to the engine install. The engine seems to put out decent power but when I mash on the gas the boost stops at 10psi (greedy boost gauge installed) and the engine looses power (stutters almost). If I gradually increase acceleration I do not notice anything wrong. I have checked both MAF and Knock Sensor, what else could I look at? When I run ECU Diagnostics (Jim Wolfe chipped) I get code 55 - All Good! I have the original PTU installed. Haven't looked at spark plugs yet. Any suggestions?
Follow Ups	Boost cuts off at 7-10psi, not getting detonation code. What - blkrocket 00:20:28 01/10/11 Re: Boost cuts off at 7-10psi, not getting detonation code. What - lurker_nz 05:04:25 01/10/11 check for boost leaks (n/m) - aliaZ 09:57:23 01/10/11 Fill in your profile. Just from what you've said so far, - zellamay 12:02:39 01/10/11 Re: Fill in your profile. Just from what you've said so far, - blkrocket 16:00:13 01/10/11 So you have stock boost solenoids. Make sure they are - zellamay 18:13:21 01/10/11 check for boost leaks and check your plugs. (n/m) - John (MD) 14:55:52 01/10/11 Re: check for boost leaks and check your plugs. - blkrocket 02:52:44 01/12/11 i also have this problem now - RedSER13 15:52:31 01/10/11 Are you running your N/A coil packs? - Josher 09:25:22 01/11/11 Thats not his issue. - Woody75 (Denver) 10:48:03 01/11/11 They are not the same Tim. - Josher 11:17:04 01/12/11 Ive seen your posts. Not sure what to tell you. (n/m) - Woody75 (Denver) 12:44:07 01/12/11
Post a Followup	You cannot reply to this message because you are not logged in.