Subject	you're assuming the worst here...
Posted by	KasbeKZ(VA) on January 06, 2011 at 4:17 PM
	This message has been viewed 92 times.
In Reply To	You could always look up the torque spec online posted by John (MD) on January 06, 2011 at 01:51 PM
Message	i searched a lot. i found debate. i was looking for a solid answer on how to install the studs. obviously i have an FSM, as it's posted online. i wasn't asking about the thermostat housing, but the thermostat itself. i have them off because i used an aftermarket timing belt and neglected to change one of my idler pulleys last time. thanks for the response.
Follow Ups	timing belt job ?'s - KasbeKZ(VA) 10:52:28 01/06/11 You could always look up the torque spec online - John (MD) 13:51:58 01/06/11 you're assuming the worst here... - KasbeKZ(VA) 16:17:35 01/06/11 T-stat just sets in place -- nothing else needed. For the - jzack 18:27:27 01/06/11 thanks. good idea (n/m) - KasbeKZ(VA) 23:06:16 01/06/11
Post a Followup	You cannot reply to this message because you are not logged in.