Subject	I have the bit,tap and screws left from my pcv reroute
Posted by	xteam300tt on January 05, 2011 at 9:23 AM
	This message has been viewed 138 times.
In Reply To	Sandblasted Valvecovers :/ posted by akdawgg99 on January 04, 2011 at 10:04 AM
Message	if you want ill part with them cheap " for cost " . you should do the pcv reroute while ur there since you have to drill out the rivets anyway. its not bad , just be careful on a couple of the rivets , the metal on the valve cover is very thin . i destroyed my first set :). read the faq on " the ultimate pcv reroute " on another note: not all stainless steel pads are the same , some will rust , read the package carefully .
Follow Ups	Sandblasted Valvecovers :/ - akdawgg99 10:04:02 01/04/11 I'd remove the baffles, clean the sand blasting media out - aliaZ 10:08:08 01/04/11 Re: I'd remove the baffles, clean the sand blasting media out - akdawgg99 10:18:06 01/04/11 Pictures don't work, but here's a description - BigTDogg (MA) 13:45:33 01/04/11 Agreed, if I were to do it again I would do the same, but... - Zinn2win 16:41:56 01/04/11 Is there a difference in N/A and TT valve covers? (n/m) - akdawgg99 13:12:17 01/04/11 No (n/m) - Woody75 (Denver) 20:16:56 01/04/11 I have the bit,tap and screws left from my pcv reroute - xteam300tt 09:23:42 01/05/11 Thank you! this is what I needed! (n/m) - akdawgg99 01:30:00 01/06/11
Post a Followup	You cannot reply to this message because you are not logged in.