Subject	Yep, you bet!
Posted by	Zarcasm(Hfd, CT) on November 21, 2010 at 10:48 AM
	This message has been viewed 432 times.
In Reply To	Di-iiiid you get ahold of him about the sender? posted by CoHPhasor on November 21, 2010 at 12:43 AM
Message	As I noted in the write-up I contacted him early on to see if I could avoid going through this whole calibration rigmarole. As far as I can tell we're using identical parts. He didn't have nearly the problems that I did. Go figure?! Good question though. Zarcasm(Hfd, CT) view My Technical posts (click here) view My General posts (click here)
Follow Ups	Oil Pressure Gage Sending Unit Replacement Woes - Zarcasm(Hfd, CT) 22:35:12 11/20/10 Di-iiiid you get ahold of him about the sender? - CoHPhasor 00:43:41 11/21/10 Yep, you bet! - Zarcasm(Hfd, CT) 10:48:24 11/21/10 Taylor and I have emailed a bit about the process. - kkrofft (OH) 16:05:39 11/21/10 Thanks for the post. - Zarcasm(Hfd, CT) 19:34:12 11/21/10 3/8 - 24 TPI <= Closest Standard Diameters and Pitch - Zarcasm(Hfd, CT) 19:41:25 11/21/10
Post a Followup	You cannot reply to this message because you are not logged in.