Subject	There are manufacturing tolerances in every part.
Posted by	zellamay on April 23, 2010 at 1:39 PM
	This message has been viewed 401 times.
In Reply To	it involves measuring the runout, and I believe it only posted by LJZTT on April 23, 2010 at 05:08 AM
Message	If, by chance, the tolerances all stack up on one side, it could cause imbalance. So reclocking the ds could cause the tolerances to cancel each other out, resulting in a balanced system.
Follow Ups	Driveshaft Issues after Z1 1-piece install on a 93 Z 2+2 - dwayne 23:26:01 04/22/10 #3 - ZLover4Life 23:33:00 04/22/10 My assumption is that it was due to u-joint operating angles - Ashman2k2 21:13:27 04/27/10 #3 - Draker (Eugene, OR) 23:41:37 04/22/10 #3 ... Had you "searched" and read up on one-piece - zellamay 00:51:26 04/23/10 I have talked to many Z'ers with the one peice Z1 Platinum - KongZTT GT28RS MD 01:10:36 04/23/10 Why? Is it that feeling of relief when you get it - zellamay 13:51:28 04/23/10 There is a procedure to properly install the driveshaft - KongZTT GT28RS MD 01:13:49 04/23/10 it involves measuring the runout, and I believe it only - LJZTT 05:08:31 04/23/10 There are manufacturing tolerances in every part. - zellamay 13:39:45 04/23/10 hmmm, so you're saying the vibration is the result of the - LJZTT 20:17:03 04/23/10 send it back for another, its obviously flawed (n/m) - Z32TT-R 03:25:19 04/23/10 EXACT same issue here, although mine is with an EPRacing - LJZTT 04:57:57 04/23/10 Re: EXACT same issue here, although mine is with an EPRacing - Tech@EPR 05:51:49 04/23/10 I understand the differences. I must not have received bolts - LJZTT 07:49:49 04/23/10 Re: I understand the differences. I must not have received bolts - Tech@EPR 09:33:35 04/23/10 Re: Driveshaft Issues after Z1 1-piece install on a 93 Z 2+2 - ak420 07:02:10 04/23/10 how would you describe the shudder? - ZiNnYc 07:05:01 04/23/10 I had problems with a 1-Piece, and went back - Trailboss 07:08:19 04/23/10 this install requires only about 3 different - KasbeKZ(VA) 07:21:12 04/23/10 If you have a worn out transmission mount or - RICH1 08:11:59 04/23/10 Re: Driveshaft Issues after Z1 1-piece install on a 93 Z 2+2 - bryan@Z1 11:38:31 04/23/10 Thanks for all the suggestions...Dwayne - dwayne 12:13:16 04/23/10 I've got a 2+2 with the Z1 DS... - xpwarrior 19:14:45 04/26/10
Post a Followup	You cannot reply to this message because you are not logged in.