Subject	Re: EGR code issues
Posted by	canyoncarver on April 08, 2010 at 5:09 AM
	This message has been viewed 95 times.
In Reply To	EGR code issues/Fuel pressure loss posted by Roundabout136 on April 05, 2010 at 07:25 AM
Message	The EGR error code only signifies an issue with the solenoid. Since you checked the solenoid for function, you might also check the ECU pin voltage outputs per the fsm, pin 102. You can also check it at the solenoid connector. [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=efec&dir=&config=&refresh=&slide=176&cycle=off&scale=0&design=default&total=190 ] If that checks o.k., trying swapping in a aiv or prvr solenoid. They are the same.
Follow Ups	EGR code issues/Fuel pressure loss - Roundabout136 07:25:10 04/05/10 Re: EGR code issues/Fuel pressure loss - de944 09:09:28 04/05/10 assuming this is a federal ECU, are you sure that it - KasbeKZ(VA) 19:16:05 04/05/10 A Federal ECU has no way to throw that code - de944 12:53:53 04/06/10 EGR is probably dirty.. - Draker (Eugene, OR) 13:23:04 04/05/10 replaced - Roundabout136 14:54:07 04/05/10 vacuum lines ok for the egr? - Brett@AwesomeZ 19:42:47 04/05/10 Re: vacuum lines ok for the egr? - Roundabout136 16:55:44 04/06/10 Re: EGR code issues - canyoncarver 05:09:27 04/08/10
Post a Followup	You cannot reply to this message because you are not logged in.