Subject	Eric...
Posted by	ParticleZX on April 06, 2010 at 7:40 PM
	This message has been viewed 148 times.
In Reply To	If you want to be able to access the injector screws without posted by Eric(FL) on April 06, 2010 at 04:24 PM
Message	That's some very nice fabric there. Ha ha. Just bustin your chops. I ground out a little more than you when I did mine. 300degree rail is a much better route than getting the head machined. The Amazing Kill Machine 300ZX!!!
Follow Ups	What Else While replacing Injectors - paul1994 12:26:42 04/06/10 If you end up pulling the plenum I would do all 6 injectors - Eric(FL) 13:47:19 04/06/10 Re: If you end up pulling the plenum I would do all 6 injectors - paul1994 14:55:36 04/06/10 You can get the hex screws at ACE Hardware or McMaster Carr. - Eric(FL) 15:45:35 04/06/10 Re: You can get the hex screws at ACE Hardware or McMaster Carr. - paul1994 16:13:52 04/06/10 If you want to be able to access the injector screws without - Eric(FL) 16:24:05 04/06/10 Eric... - ParticleZX 19:40:56 04/06/10 LOL, thanks. I thought someone might say something about - Eric(FL) 21:29:04 04/06/10 Yeah... - ParticleZX 00:02:13 04/09/10 Tackle the EGR, it's not hard. Search for the method. - zellamay 16:05:29 04/06/10 I question fuel smell in the cabin as a sign of a - zellamay 14:19:44 04/06/10 Re: I question fuel smell in the cabin as a sign of a - paul1994 14:51:50 04/06/10 I'm not sure about a small fuel leak causing rough idle. - zellamay 15:45:37 04/06/10 Fuel smell is indicative of a leak. Rough idle is usually a - Eric(FL) 15:51:58 04/06/10 Many Thanks for the Replies - paul1994 16:17:37 04/06/10 I'd find that fuel leak FIRST! - BoneZ 20:11:35 04/06/10 I hope you're joking. ...................................... (n/m) - zellamay 02:17:39 04/07/10 Yep ;) ....... (n/m) - paul1994 16:03:10 04/07/10
Post a Followup	You cannot reply to this message because you are not logged in.