Subject	not sure if I read that correctly, but sounds like you have
Posted by	LJZTT on April 03, 2010 at 5:20 AM
	This message has been viewed 92 times.
In Reply To	Sorry, but I have a question about boost. posted by CoHPhasor on April 03, 2010 at 04:46 AM
Message	a leak in the signal line for the boost sensor. Small enough that under vacuum it sucks it shut and registers on the gauge, but large enough that the air escapes under pressure and your gauge registers nothing. Or your gauge itself and/or the sensor is broken, assuming your turbos are functioning at all. Just my guess. "The American people will never knowingly adopt socialism. But, under the name of "liberalism", they will adopt every principle of our socialist program, until one day America will be a socialist nation, without ever knowing how it happened.... I no longer need to run on the Socialist Party ticket because the Democrat Party has now adopted our platform." --Norman Thomas, 1944 Socialist Party Presidential Candidate "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill
Follow Ups	Sorry, but I have a question about boost. - CoHPhasor 04:46:57 04/03/10 not sure if I read that correctly, but sounds like you have - LJZTT 05:20:25 04/03/10 Definitely what I'm trying to figure out - CoHPhasor 05:24:09 04/03/10 lower than that actually, but the OEM gauge is "approximate" - LJZTT 05:50:57 04/03/10 interesting. Either I'm -12:0, I'm higher and it's lying, or - CoHPhasor 05:56:54 04/03/10 what I am trying to say is dont worry about the numeric - LJZTT 11:31:09 04/03/10 Sounds like a seized turbo. - Draker (Eugene, OR) 15:02:11 04/03/10 An easy gauge check - ConVerTT 11:02:59 04/03/10 My test gauge was $15 from Pepboys. - Woody75 (Denver) 12:07:39 04/06/10 I'd pull the down pipes off and check for a seized turbo. - Wright (Ca) 09:50:39 04/03/10 if the boost leak is THAT big, the car wont rev much past 3k - LJZTT 11:33:55 04/03/10 Have you ever owned or been in a z before? - pearlzed(toronto) 10:27:44 04/03/10 I was out today, but will look deeper. May need an SF Z'er. - CoHPhasor 01:55:39 04/04/10 Ok, finally got to check it out, - CoHPhasor 04:45:10 04/07/10 Still sounds like a bad/frozen turbo. - Woody75 (Denver) 07:35:01 04/07/10 That stinks. So pull the pipes to gain access to them? - CoHPhasor 11:59:04 04/07/10
Post a Followup	You cannot reply to this message because you are not logged in.