Subject	Personally, being a touch OCD, I'd redo it
Posted by	Broke_as_**** on April 02, 2010 at 1:50 AM
	This message has been viewed 78 times.
In Reply To	I think I will just bend the pipe posted by ZXRider on April 02, 2010 at 01:27 AM
Message	But once you have a good idea about how much you need to bend it and in which way, secure the pipe in a vice with the end going towards the back of the motor in the jaws. Then using a large screw driver, small pry bar or any other suitable tool inserted into the flange end facing the front of the motor bend it slowly. Heating it up shouldn't be necessary for the small amount of bend you'll probably need. On the bright side, if it goes wrong, you can probably get another pipe section for like $5.
Follow Ups	Water Pipe - ZXRider 22:55:37 04/01/10 Looks like it got twisted somehow..? - Draker (Eugene, OR) 23:52:06 04/01/10 Well - Broke_as_**** 00:50:54 04/02/10 I think I will just bend the pipe - ZXRider 01:27:02 04/02/10 Personally, being a touch OCD, I'd redo it - Broke_as_**** 01:50:15 04/02/10 While I would like to redo it the problem is - ZXRider 02:46:26 04/02/10 Done it a few times - Broke_as_**** 11:55:13 04/02/10 ***Update*** - ZXRider 03:06:55 04/02/10 Re: Water Pipe - canyoncarver 17:10:35 04/02/10
Post a Followup	You cannot reply to this message because you are not logged in.