Subject	To balance or not to balance...
Posted by	mrtoolz on March 25, 2010 at 8:30 PM
	This message has been viewed 130 times.
Message	The need has finally arisen for me to pull my motor and rebuild it. The motor is out of the car and on the stand in my garage and I'm working on it as time permits, and I'm planning on putting the wiseco / eagle setup back in it, but I was wondering if anyone had any expierience with balancing the crank, pistons and connecting rods before installing them. I was thinking about doing it eitherway, but was hoping for some feedback before I do it so I have something to compare to. I have a machine shop to do it if I decide to, but again, was hoping for some feedback. Thanks!
Follow Ups	To balance or not to balance... - mrtoolz 20:30:49 03/25/10 Re: To balance or not to balance... - canyoncarver 19:37:49 03/26/10
Post a Followup	You cannot reply to this message because you are not logged in.