| Message |
Hey guys... I am grasping at straws here, but if anyone has a stock, unmolested throttle body laying around, I need to know in thousandths approximately the gap on the stock throttle plate. I have been chasing an idle hunting issue since my last build, and I have 55mm throttle bodies with the plates set to about .002" at Ash's direction. I know Ash runs His doolz intake, and I am running dual Mafs. I also have a condition according to Datascan where the AAC is running at 12% duty cycle and it's supposed to be at 15% minimum. It's got me to thinking that maybe the throttle plates are gapped a little too much, allowing the AAC to relax, and also adding more air than should be thereby causing my idle issue. The car runs like a raped ape other than this idle thing. Getting closer!! Eric
|
 |
