Subject	Thanks Wright! Any advice is very helpful at this point
Posted by	Kels300Z on March 16, 2010 at 11:27 PM
	This message has been viewed 64 times.
In Reply To	I couldn't have done it without a second set of hands. Also, posted by Wright (Ca) on March 16, 2010 at 11:08 PM
Message	Might give it one more go for posterity before bed. If that's no good then I'll take it to a shop tomorrow and impact-wrench those suckers. The day you stop learning about this car is the day you're no longer an enthusiast.
Follow Ups	Ball joint assembly removal is at a standstill. Suggestions? - Kels300Z 22:12:00 03/16/10 Do you have the ball joint press that he uses later in the - Wright (Ca) 22:35:32 03/16/10 Yep! Still having problems with it. - Kels300Z 22:52:47 03/16/10 I couldn't have done it without a second set of hands. Also, - Wright (Ca) 23:08:43 03/16/10 Thanks Wright! Any advice is very helpful at this point - Kels300Z 23:27:18 03/16/10 Re: Ball joint assembly removal is at a standstill. Suggestions? - lurker_nz 23:33:42 03/16/10 Nice! I will definitely try that as well. Thanks lurker! (n/m) - Kels300Z 23:36:44 03/16/10 Success! SPL solids are now in place! Many thanks again. (n/m) - Kels300Z 14:54:08 03/17/10
Post a Followup	You cannot reply to this message because you are not logged in.