Subject	I couldn't have done it without a second set of hands. Also,
Posted by	Wright (Ca) on March 16, 2010 at 11:08 PM
	This message has been viewed 80 times.
In Reply To	Yep! Still having problems with it. posted by Kels300Z on March 16, 2010 at 10:52 PM
Message	I believe I found a longer bolt to thread into the back of the ball joint. Then press against that. The press kit should have whatever you might need for the end that the ball joint slips into. Sorry I can't be more helpfull. BTW, it took a lot of force to get it to start coming out. Formerly: ZEVAN (Ca), Evan3zx(ca) Xbox live GT: kidding Me 1991 CRP TT 1993 Pearl White NA
Follow Ups	Ball joint assembly removal is at a standstill. Suggestions? - Kels300Z 22:12:00 03/16/10 Do you have the ball joint press that he uses later in the - Wright (Ca) 22:35:32 03/16/10 Yep! Still having problems with it. - Kels300Z 22:52:47 03/16/10 I couldn't have done it without a second set of hands. Also, - Wright (Ca) 23:08:43 03/16/10 Thanks Wright! Any advice is very helpful at this point - Kels300Z 23:27:18 03/16/10 Re: Ball joint assembly removal is at a standstill. Suggestions? - lurker_nz 23:33:42 03/16/10 Nice! I will definitely try that as well. Thanks lurker! (n/m) - Kels300Z 23:36:44 03/16/10 Success! SPL solids are now in place! Many thanks again. (n/m) - Kels300Z 14:54:08 03/17/10
Post a Followup	You cannot reply to this message because you are not logged in.