Subject	Ball joint assembly removal is at a standstill. Suggestions?
Posted by	Kels300Z on March 16, 2010 at 10:12 PM
	This message has been viewed 177 times.
Message	I'm currently following sawbonez' FAQ on removing the ball joint assemblies from the rear toe arms. Those suckers just won't budge, and this is with the subframe off of the car! Plus I'm having problems keeping the c-clamp from spinning off the pipe end-cap as sawbonez illustrated. Any suggestions/advice would be very helpful. Thanks guys! -Kel The day you stop learning about this car is the day you're no longer an enthusiast.
Follow Ups	Ball joint assembly removal is at a standstill. Suggestions? - Kels300Z 22:12:00 03/16/10 Do you have the ball joint press that he uses later in the - Wright (Ca) 22:35:32 03/16/10 Yep! Still having problems with it. - Kels300Z 22:52:47 03/16/10 I couldn't have done it without a second set of hands. Also, - Wright (Ca) 23:08:43 03/16/10 Thanks Wright! Any advice is very helpful at this point - Kels300Z 23:27:18 03/16/10 Re: Ball joint assembly removal is at a standstill. Suggestions? - lurker_nz 23:33:42 03/16/10 Nice! I will definitely try that as well. Thanks lurker! (n/m) - Kels300Z 23:36:44 03/16/10 Success! SPL solids are now in place! Many thanks again. (n/m) - Kels300Z 14:54:08 03/17/10
Post a Followup	You cannot reply to this message because you are not logged in.