Subject	Use a short wood block, leverage it under the part of
Posted by	jzack on March 10, 2010 at 10:29 PM
	This message has been viewed 77 times.
In Reply To	exhaust valve cover removal question posted by randy (detroit) on March 10, 2010 at 08:30 PM
Message	the VC that extends out a bit over the block (side of VC closest to to center of engine), and whack with a mallet. Do the leveraging in a few spots and that side of the VC will start to come up....
Follow Ups	exhaust valve cover removal question - randy (detroit) 20:30:59 03/10/10 If you have all 8 bolts out, all that is holding it is the - na300zx (OH) 20:36:56 03/10/10 I usually use a paint scrapper and hammer my way through the - JonnyZ(SoCal) 20:44:50 03/10/10 Yep. What Jonny said..... - Zxpress 16:50:15 03/11/10 Use a short wood block, leverage it under the part of - jzack 22:29:39 03/10/10
Post a Followup	You cannot reply to this message because you are not logged in.