Subject	Installed my emblem on a Stillen center panel...
Posted by	Zxtec on March 10, 2010 at 10:15 PM
	This message has been viewed 154 times.
In Reply To	To those with '99 JDM front emblems... posted by Under_Powered on March 10, 2010 at 05:58 PM
Message	I did this about 7 years ago so, from what I can recall, I just used wire cutters to cut each pin off. You probably can use a dremel or file to clean it up. Just make sure there are no stubs that protrude above the mounting adhesive.
Follow Ups	To those with '99 JDM front emblems... - Under_Powered 17:58:23 03/10/10 Installed my emblem on a Stillen center panel... - Zxtec 22:15:01 03/10/10 thanks, wire cutters did the trick just fine. - Under_Powered 17:12:28 03/11/10
Post a Followup	You cannot reply to this message because you are not logged in.